Non-visible structurals
Door Carrier
This automotive lighting mould has below features:
1、The part is about 700X500mm size;
2、Long glass fiber mixed resin, which requested special technology in hot runner and tool building method to avoid the broken GF;
3、Very big warpage on part, needs special know-how to correct it.
Front-End Module （FEM Carrier）
This automotive lighting mould has below features:
1、The part is about 1200X500mm size;
2、Long glass fiber mixed resin, which requested special technology in hot runner and tool building method to avoid the broken GF;
3、large size part and Tool, 1500T injection machine at least, with 3 RJG pressure sensors.
Intake manifold
This automotive lighting mould has below features:
1、The part is about 400X300mm size;
2、Very Complicated part and tool structure.
3、Tight profile tolerance request for welding Upper, Middle and Lower together.
Sun roof assembly
This automotive lighting mould has below features:
1、It is two parts in the assembly, front and rear frame. The part is about 900X350mm size for each;
2、Very Complicated part and a lot of shutoff details.
3、Very big warpage on part, needs special know-how to correct it.
Center Console Carrier
This automotive lighting mould has below features:
1、The part is about 700X350mm size;
2、Very complicated part and a lot of ribs working on tool.
3、Large tool, 4 sides big sliders with Ejector Pin system.
Air Gate
This automotive lighting mould has below features:
1、The part is about 750X600mm size;
2、6 drops valve needle gates hot runner.
3、Very big warpage on part, needs special know-how to correct it.
AVAC Cover
This automotive lighting mould has below features:
1、The part is about 550X300mm size;
2、Very complicated part and a lot of ribs working on tool. Staubli water manifold system.
3、Large tool and mostly 1+1 cavity tool as Upper and Lower together.
Cover Wing
This automotive lighting mould has below features:
1、The part is about 750X150mm size;
2、Resin is PP-EPDM+TPR, L+R in total 4 cavity..
3、Large rotating 2K mold, laser hardened parting lines.
Engine Cover
This automotive lighting mould has below features:
1、The part is about 650X550mm size;
2、6 drops valve needle gates hot runner.
3、Large tool on 1300T injection molding machine.
Active Grille System (AGS)
This automotive lighting mould has below features:
1、The frame part is about 680X400mm size;
2、there is 1 frame and 10 laminae in the assembly.
3、Large Core Back System 2K tool for the frame, and rotating 2K for the laminae.
