We are trusted by many well-known Tier-1 and Tier-2 Automotive component manufacturers for all over the world.
Kuasu has a unique advantage in the field of automotive parts and accessories, especially interior and exterior parts. We are especially good at designing and manufacturing injection molds for medium-large and complex structures. Serving the world's top 100 auto parts customers, we have experience in cooperation and know the product standards. It is not an exaggeration to say that we can make injection molds for any injection molded parts in a car. At present, we have provided more than 90% of the injection molds for a car. Boze, Lear, Yanfeng, Magna, Aisin Seiki, etc. are our cooperative customers. We have been awarded the Tier 1 and Tier 2 supplier code of many car companies.
Automotives
Door Carrier
This automotive lighting mould has below features:
1、The part is about 700X500mm size;
2、Long glass fiber mixed resin, which requested special technology in hot runner and tool building method to avoid the broken GF;
3、Very big warpage on part, needs special know-how to correct it.
Front-End Module （FEM Carrier）
This automotive lighting mould has below features:
1、The part is about 1200X500mm size;
2、Long glass fiber mixed resin, which requested special technology in hot runner and tool building method to avoid the broken GF;
3、large size part and Tool, 1500T injection machine at least, with 3 RJG pressure sensors.
Grilles
This automotive lighting mould has below features:
1. Deep cavity mould.
2. Big drop of the parting ling surface.
3. Complicated part structure.
Intake manifold
This automotive lighting mould has below features:
1、The part is about 400X300mm size;
2、Very Complicated part and tool structure.
3、Tight profile tolerance request for welding Upper, Middle and Lower together.
Sun roof assembly
This automotive lighting mould has below features:
1、It is two parts in the assembly, front and rear frame. The part is about 900X350mm size for each;
2、Very Complicated part and a lot of shutoff details.
3、Very big warpage on part, needs special know-how to correct it.
Center Console Carrier
This automotive lighting mould has below features:
1、The part is about 700X350mm size;
2、Very complicated part and a lot of ribs working on tool.
3、Large tool, 4 sides big sliders with Ejector Pin system.
Air Gate
This automotive lighting mould has below features:
1、The part is about 750X600mm size;
2、6 drops valve needle gates hot runner.
3、Very big warpage on part, needs special know-how to correct it.
AVAC Cover
This automotive lighting mould has below features:
1、The part is about 550X300mm size;
2、Very complicated part and a lot of ribs working on tool. Staubli water manifold system.
3、Large tool and mostly 1+1 cavity tool as Upper and Lower together.
Cover Wing
This automotive lighting mould has below features:
1、The part is about 750X150mm size;
2、Resin is PP-EPDM+TPR, L+R in total 4 cavity..
3、Large rotating 2K mold, laser hardened parting lines.
Engine Cover
This automotive lighting mould has below features:
1、The part is about 650X550mm size;
2、6 drops valve needle gates hot runner.
3、Large tool on 1300T injection molding machine.
